Drain stoppers are a common plumbing fixture used to control the flow of water in a sink or bathtub. Although they are small and simple devices, drain stoppers can sometimes get stuck, causing frustration and inconvenience for homeowners. One common problem with drain stoppers is when they get stuck in a brass fitting.
If your drain stopper is stuck in a brass fitting, don’t panic. There are several steps you can take to remove it safely and quickly without causing any damage to your plumbing system. In this article, we will discuss some tips and tricks for removing a drain stopper that is stuck in a brass fitting.
1. Turn off the Water
The first step in removing a stuck drain stopper is to turn off the water supply. Locate the shut-off valves under the sink and turn them clockwise to close them. Then, turn on the faucet to release any remaining water in the sink or bathtub.
2. Remove the Drain Stopper Knob
The next step is to remove the knob on the top of the drain stopper. Most drain stoppers have a screw in the middle that holds the knob in place. Use a screwdriver to loosen and remove the screw, then lift off the knob.
3. Loosen the Brass Fitting
Once you have removed the knob, you can begin to loosen the brass fitting. Use a pair of pliers to grip the fitting and turn it counterclockwise. If the fitting is stuck, you may need to use a lubricant such as WD-40 to help loosen it.
4. Remove the Drain Stopper
Once the brass fitting is loose, you can remove the drain stopper. Carefully pull the stopper up and out of the drain. If it is still stuck, you may need to apply more lubricant and use a pair of pliers to gently wiggle it free.
5. Clean the Drain
After removing the drain stopper, take the opportunity to clean any debris or buildup from the drain. You can use a plumbing snake or a wire hanger to remove any clogs or blockages.
6. Reassemble the Drain Stopper
Once you have cleaned the drain, it’s time to reassemble the drain stopper. Make sure the rubber gasket is in place and then insert the stopper back into the drain. Reattach the brass fitting and turn it clockwise to tighten it in place. Replace the knob and screw, and turn on the water supply.
Conclusion
Removing a drain stopper stuck in a brass fitting can be tricky, but it’s not impossible. By following these simple steps, you can safely and effectively remove the stopper without causing any damage to your plumbing system. Remember to always turn off the water supply and use caution when working on plumbing fixtures. If you are unsure about any step in the process, don’t hesitate to contact a plumbing professional for assistance. For all your plumbing needs, visit our website at aceplumbingrepair.com or give us a call at (844) 711-1590. Our experienced plumbers are available 24/7 to assist you with all your plumbing needs.
Call Now